 |
|||
|
|
|||
|
Page Title:
Wire Harness (WI), Removal/Installation-cont. |
|
||
| ||||||||||
|
|
 TM 32-5865-069-24&P
..
(4)
Lower and support the panel.
(5)
Remove and retain the threaded bushing from the circuit breaker
actuator shaft.
Carefully unsolder the connections to the front mounted components served
d.
by W1 (i.e., all except M1 and S3).
Unsolder wires numbered 323 and 397 from S3.
e.
CAUTION
When unfastening cable-ties,
take care not to cut or damage the
wiring in harness W21.
f.
Remove the tie securing the wiring around S3.
Unfasten the cable-ties securing the harness to the front panel and to
g.
harness W21.
h.
Unsolder the wires connected to S4.
Unsolder all wires connected to A17 (9 connections).
i.
Remove and retain the hardware securing ground-tree E5 to the chassis.
j.
Raise the front panel and temporarily secure using two of the screws
k.
retained in step c.
l.
Carefully remove all the back-plane connectors from A15.
CAUTION
When unfastening cable-ties, take care not to damage the wiring in
harness W21.
Unfasten the two cable-ties securing harness W21 to the bottom right side
m.
of the chassis.
n.
Unfasten the cable-ties securing harness W1 to harness W21.
0.
Unsolder the connection to A15W1-2.
Unsolder the connections to A15W1-1, A15W2 and A15W3.
p,
Remove and retain the hardware securing A15E1.
q.
Remove and retain the hardware securing the two cable clamps supporting the
r,
harness on A15. Remove the clamps and retain for reassembly. Remove PS1,
refer to para 5-4.6.
s,
Unsolder wires numbered 352, 400, 309, 311, 401 and 405.
t,
Loosen the screw in the retainer block for TB1 and remove TB1-3 thru TB1-8.
5-33
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals