Section I. INTRODUCTION - TM-32-5410-221-14-P0044

TM 32-5410-221-14&P

APPENDIX B

COMPONENTS OF END ITEM LIST

Section I. INTRODUCTION

B-1

SCOPE.

This appendix lists integral

(2) Item Number.

The number used to

components of and Basic Issue Items (BII) for Electrical

identify item called out in the illustration.

Equipment Shelter S-281/G to help you inventory items

required for safe and efficient operation.

b. National Stock Number. Indicates the National

stock number assigned to the item and which will be

B-2

GENERAL. This Components of End Item List

used for requisitioning.

is divided into the following sections:

c. Part Number. Indicates the primary number

used by the manufacturer, which controls the design and

a. Section II. Integral Components of the End

characteristics of the item by means of its engineering

Item. These items, when assembled, comprise the S-

drawings, specifications, standards, and inspection

281/G and must accompany it whenever it is transferred

requirements to identify an item or range of items.

or turned in. The illustrations will help you identify these

d. Description. Indicates the Federal item name

items.

and, if required, a minimum description to identify the

b. Section III. Basic Issue Items (BII). These are

item.

the minimum essential items required to place the S-

e. Location. The physical location of each item

281/G in operation, to operate it, and to perform

listed is given in this column. The lists are designed to

emergency repairs.

Although shipped separately

inventory all items in one area of the major item before

packed they must accompany the S-281/G during

moving on to an adjacent area.

operation and whenever it is transferred between

f. Usable on Code. "USABLE ON" codes are

accountable officers. The illustrations will assist you

included to help you identify which component items are

with hard-to-identify items.

This manual is your

used on the different models. Identification of the codes

authority to requisition replacement BII, based on

used in these lists are: none.

TOE/MTOE authorization of the end item.

g. Quantity Required (Qty Req'd). This column

lists the quantity of each item required for a complete

B-3

EXPLANATION OF COLUMNS.

major item.

h. Quantity. This column is left blank for use

a. Illustration. This column is divided as follows:

during an inventory. Under the Rcv'd column, list the

quantity you actually receive on your major item. The

(1) Figure Number.

Indicates the figure

Date columns are for your use when you inventory the

number of the illustration on which the item is shown:

major item at a later date; such as for shipment to

another site.

B-1