CHAPTER 4 OPERATOR/CREW MAINTENANCE INSTRUCTIONS

TM 32-5410-221-14&P

CHAPTER 4

OPERATOR/CREW MAINTENANCE INSTRUCTIONS

Not Applicable

CHAPTER 5

ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

Section I. TOOLS AND EQUIPMENT

illustrated in Appendix E.

5-1

TOOLS AND EQUIPMENT. Tools and test

equipment required are listed in Appendix D. There are

5-3

MATERIALS. Necessary materials are listed

no special tools or test equipment required.

in Appendix F. There are no special materials required.

5-2

REPAIR PARTS.

Necessary repair parts are

listed and

Section II. REPAINTING AND REFINISHING INSTRUCTIONS

CAUTION

Do not paint electrical switches or

contacts, plastic surfaces, sliding

Solar-reflecting paint per MIL-E-

part contact surfaces, identification

46061 (MO) has been used to paint

plates or other printed information,

the exterior of some shelter facilities

or light unit window panels.

to lower the inside temperature when

5-4

REPAINTING,

REFINISHING,

AND

the shelter is exposed to direct rays

RETOUCHING. Repainting, refinishing, and retouching

of the sun.

of the shelter must be in accordance with TB 43-0118,

Field Instructions for Painting and Preserving

Before painting shelter exterior,

Electronics

Command

Equipment,

Including

check for a solar-reflecting paint

Camouflage Pattern Painting of Electrical Equipment

caution notice located on the rear

Shelters. Paints and finishes must be in accordance

wall exterior next to the door. Do not

with SB 11-573, Painting and Preservation Supplies

use paint other than that specified in

Available for Field Use for Electronics Command

TB 43-0124 on shelter exteriors with

Equipment, and AR 746-1, Packaging of Army Materiel

solar-reflecting paint.

for Shipment and Storage.

Section III. LUBRICATION INSTRUCTIONS

5-5

GENERAL. There is no lubrication order for the

a. Shelter Door. Apply a light film of oil, item 15,

S-281/G. Lubrication is limited to the sliding and

Appendix F, to shelter door hinges and latch assembly.

rotating parts listed below. These parts should be

b. Power Cable Reel. Apply a light film of oil, item

checked and lubricated quarterly as required. Checks

15, Appendix F, to the bearings.

should be more often when operating under unusual

conditions.

Refer to the applicable manual for

lubrication of the air conditioners.

4-1/5-1