 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 3-1040-279-12&P
4-36 AIR COMPRESSOR ASSEMBLY (CONT).
a. Pressure Tank.
REMOVAL
1.
Disconnect air hose assembly (1) from straight adapter (2).
2.
Remove control valve (3) with reducer (4) from pipe tee (5).
3.
Remove pipe tee (5) with straight adapter (2).
4.
Disconnect air hose assembly (6) from elbow (7) on pressure tank (8).
5.
Remove two pipe bushings (9) with disconnect coupling (10) from pressure tank (8).
6.
Remove cable loop clamp (11) for access.
7.
Remove eight screws (12), washers (13), and four retaining straps (14) and remove pressure tank
(8) from frame assembly (15).
8.
Remove elbow (7) from pressure tank (8).
INSTALLATION
NOTES
Apply sealing compound (Item 12, App E) to threads of male pipe fittings
before installing.
If required, replace insulation tape (Fig. G-16) on frame assembly's pressure
tank mounting brackets, as required.
1.
Install elbow (7) on pressure tank (8).
2.
Position pressure tank (8) on compressor frame assembly (15) and secure with four retaining straps
(14), eight screws (12) and washers (13). Do not over-tighten screws (12). A gap between retaining
strap (14) and frame assembly (15) is permissible.
3.
Install cable loop clamp (11).
4.
Install two pipe bushings (9) with disconnect couplings (10) on pressure tank (2).
5.
Connect air hose assembly (6) to elbow (7).
6.
Install pipe tee (5) with straight adapter (2) on pressure tank (2).
7.
install reducer (4) and control valve (3) on pipe tee (5).
8.
Connect air hose assembly (1) to pressure tank (8).
4-152
Change 4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals