CHAPTER 3 DIRECT SUPPORT MAINTENANCE INSTRUCTIONS

TM 3-1040-276-23

CHAPTER 3

DIRECT SUPPORT MAINTENANCE INSTRUCTIONS

Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT,

AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

3-2. SPECIAL TOOLS, TMDE, AND SUPPORT

3-1. COMMON TOOLS AND EQUIPMENT. For autho-

EQUIPMENT. Refer to Maintenance Allocation Chart

rized common tools and equipment, refer to the Modi-

fied Table of Organization and Equipment (MTOE)

(app B) for support equipment.

assigned to your unit.

3-3. REPAIR PARTS. Repair parts are listed and illus-

trated in TM 3-1040-276-23P.

Section Il. DIRECT SUPPORT MAINTENANCE PROCEDURES

3-4. INTRODUCTION.

to 24 hours after operation. Use two peo-

ple at nozzle end, one on each side, to lift

a. This section contains maintenance procedures

and carry a hot smoke generator.

which are the responsibility of the direct support

maintenance technician as authorized by the mainte-

b. One quartermaster and chemical equipment

nance allocation chart (MAC) (app B) and source,

repairer (MOS 63J) can do most tasks alone. However,

maintenance, and recoverability (SMR) coded items in

it takes two people to lift and carry the smoke genera-

the repair parts and special tools list (RPSTL)

tor, engine assembly, or frame assembly. A welder is

(TM 3-1040-276-23P).

also needed, to weld the frame. No special environmen-

tal conditions are listed because none are required.

WARNING

Flames, hot gases, or hot fog oil may

shoot out from smoke outlet nozzles up

3-1