Tool and Test Equipment Requirements - TM-11-6625-542-14-10056

TM 11-6625-542-14-1

specifies by code, those common tool sets (not individual

the group numbers in the MAC and RPSTL coincide.

d. Column 4, Maintenance Category. Column 4

tools) and special tools, test, and support equipment

required to perform the designated function.

specifies, by the listing of a "worktime" figure in the

appropriate subcolumn (s), the lowest level of

C4. Tool and Test Equipment Requirements (Table

maintenance authorized to perform the function listed in

column 3. This figure represents the active time required

a. Tool or Test Equipment Reference Code. The

to perform that maintenance function at the indicated

numbers in this column coincide with the numbers used

category of maintenance. If the number or complexity of

in the tools and equipment column of the MAC. The

the tasks within the listed maintenance function vary at

numbers indicate the applicable tool or test equipment

different maintenance categories, appropriate "worktime"

for the maintenance functions.

figures will be shown for each category. The number of

b. Maintenance Category. The codes in this

man-hours specified by the "worktime" figure represents

column indicate the maintenance category allocated the

the average time required to restore an item (assembly,

tool or test equipment.

subassembly, component, module, end item or system)

c. Nomenclature. This column lists the noun

to a serviceable condition under typical field operating

name and nomenclature of the tools and test equipment

conditions.

This time includes preparation time,

required to perform the maintenance functions.

troubleshooting time and quality assurance/quality

d. National/NATO Stock Number. This column

control time in addition to the time required to perform

lists the National/NATO stock number of the specific tool

the specific tasks identified for the maintenance

or test equipment.

functions authorized in the maintenance allocation chart.

e. Tool Number.

This column lists the

Subcolumns of column 4 are as follows:

manufacture's part number of the tool followed by the

C--Operator/crew

Federal Supply Code for manufacturers (5-digit) in

0- Organizational

parentheses.

F--Direct support

H--General support

D-Depot

Column 5, Tools and Equipment. Column 5

C-2