Tool and Test Equipment Requirements - TM-11-6625-537-14-10064

TM 11-6625 -537-14-1

e. Column 5, Tools and Equipment. Column 5

specifies, by the listing of a "worktime" figure in

specifies by code, those common tool sets (not

the appropriate subcolumn(s), the lowest level of

i n d i v i d u a l tools) and special tools, test, and

maintenance authorized to perform the function

s u p p o r t equipment required to perform the

listed in column 3. This figure represents the

designated function.

active time required to perform that maintenance

f u n c t i o n at the indicated category of main-

C-4. Tool and Test Equipment Requirements

tenance. If the number or complexity of the tasks

(Table 1)

within the listed maintenance function vary at

a. Tool or Test Equipment Reference Code.

different maintenance categories, appropriate

The numbers in this column coincide with the

" w o r k t i m e " f i g u r e s will be shown for each

numbers used in the tools and equipment column

category. The number of man-hours specified by

of the MAC. The numbers indicate the applicable

the " worktime" figure represents the average

t o o l or test equipment for the maintenance

t i m e required to restore an item (assembly,

functions.

subassembly, component, module, end item or

b. Maintenance Category. The codes in this

system) to a serviceable condition under typical

column i n d i c a t e the maintenance category

field operating conditions. This time includes

allocated the tool or test equipment.

p r e p a r a t i o n time, troubleshooting time and

c. Nomenclature. This column lists the noun

q u a l i t y assurance/quality control time in ad.

name and nomenclature of the tools and test

d i t i o n a l to the time required to perform the

equipment required to perform the maintenance

s p e c i f i c tasks identified for the maintenance

functions.

authorized

functions

the

maintenance

d . National/NA TO Stock Number. T h i s

allocation chart. Subcolumns of column are as

column lists the National/NATO stock number of

follows:

the specific tool or test equipment.

Operator/crew

e. T o o l N u m b e r . T h i s c o l u m n l i s t s t h e

organizational

()

manufacturer's part number of the tool followed

Direct support

by the Federal Supply Code for manufacturers (5-

General support

digit) in parentheses.

Depot

C-2