SECTION I INTRODUCTION - TM-11-6625-241-20P0002

SECTION I

INTRODUCTION

Code

Explanation

1-1. Scope

This manual lists repair parts and special tools required

PE --

Support equipment procured and stocked for

for the performance of organizational maintenance of the

initial issue or outfitting to specified

ZM-3/U and ZM-3.U. The PCCN for the equipment is

maintenance repair activities.

GCWAJF for all models.

PF --

Support equipment which will not be stocked

but which will be centrally procured on

1-2. General

demand.

PG --

Item procured and stocked to provide for

This repair parts and special tools list is divided into the

sustained support for the life of the

following sections:

equipment. It is applied to an item peculiar

a Prescribed Load Allowance (PLA) - Section II.

to the equipment which because of probable

Not applicable.

discontinuance or shutdown of production

b. Repair Parts List - Section III. A list of repair

facilities would prove uneconomical to

parts authorized for the performance of maintenance at

reproduce at a later time.

the organization level. This repair parts lists arranged in

KD --

An item of depot overhaul/repair kit and not

alphabetical order.

purchased separately. Depot kit defined as

c. Special Tools, Test and Support Equipment -

a kit that provides items required at the time

Section IV. Not applicable.

of overhaul or repair.

Index - Federal Stock Number and

KF --

An item of a maintenance kit and not

Reference Number Cross-Reference to Figure and Item

purchased separately.

Maintenance kit

Number - Section V. A list, in ascending numerical

defined as a kit that provides an item that

sequence, of all reference number appearing in the

can be replaced at organizational or direct

listings. Federal stock number and reference numbers

support or general support levels or

are cross-reference to each illustration figure and item

maintenance.

number or reference designation appearance.

KB --

Item included in both a depot over haul/repair

kit and a maintenance kit.

1-3. Explanation of Columns

MO --

Item to be manufactured or fabricated at direct

support maintenance level.

The following provides an explanation of columns in the

MF --

Item to be manufactured or fabricated at direct

tabular lists --

support maintenance level.

a. Source, Maintenance, and Recoverability

MH --

Item to be manufactured or fabricated at

Codes (SMR).

general support maintenance level.

(1) Source Code. Indicates the manner of

MD --

Item to be manufactured or fabricated at depot

acquiring support items for maintenance, repair, or

maintenance level.

overhaul of end items. Source codes are--

AO --

Item to be assembled at organizational level.

AF --

Item to be assembled at general support

Code

Explanation

maintenance level.

PA --

Item procured and stocked for anticipated or

AD --

Item to be assembled at depot maintenance

known usage.

level.

PB --

Item procured and stocked for insurance

XA --

Item is not procured or stocked because the

purposes because essentiality dictates that

requirements for the item will result in the

a minimum quantity be available in the

replacement of the next higher assembly.

supply systems.

XB --

Item is not procured or stocked.

If not

PC --

Item procured and stocked and which

available through salvage, requisition.

otherwise would be coded PA except that it

Installation drawing, diagram instruction sheet,

is deteriorative in nature/

field service drawing, that is identified by

PD --

Support item, excluding support equipment,

manufacturers' part number.

procured for initial issue or outfitting and

XD --

Support items can be requisitioned with

stocked only for subsequent or additional

justification.

initial issues or outfittings. Not subject to

automatic replenishment.