CONNECTOR UG-1870A/U REPLACEMENT (CONT) - TM-11-5995-208-24-P-10031

TM 11-5995-208-24&P-1

CONNECTOR UG-1870A/U REPLACEMENT (CONT)

CAUTION

Many parts are coated with sealants and lubricants. Do not remove these materials from

parts.

When laying parts out, do not allow parts to become dirty. Place them in a clean tray or on a

Iint-free cloth.

2. Lay out new connector parts as shown on previous page.

NOTE

The ID tag is in addition to original tag on cable, and is locally procured. The ID tag Should

include: nomenclature, length, year and month, type of action, (i. e., OVH for overhaul)

(repair of CX-11230A/G) by replacing connector UG-1870A/U; FAB for fabrica-

tion (making 100-foot lengths from 1/4-mile lengths); or SCR for screened (screening by

a designated activity), and unit identification (who did the OVH, FAB, or SCR).

3. Place proper ID tag (1) over end of cable, and install it back at least 16 inches.

CAUTION

Be careful not to nick or cut outer copperweld braid when trimming outer jacket.

4. Trim outer jacket (2) to 2 55/64 1/16 inches from cut end.

3-5