Tool and Test Equipment Requirements - TM-11-5935-212-13P0014

TM 11-5935-212-13P

maintenance authorized to perform the function

f . Column 6, Remarks. Column 6 contains an al-

phabetic code which leads to the remark in section

listed in column 3. This figure represents the active

I V , Remarks, which is pertinent to the item oppo-

t i m e required to perform that maintenance func-

site the particular code.

t i o n at the indicated category of maintenance. If

t h e number or complexity of the tasks within the

C-4.

Tool

and

Test

Equipment

Require-

listed maintenance function vary at different

ments (Sect. Ill)

maintenance categories, appropriate "work time"

a. Tool or Test Equipment Reference Code. T h e

figures will be shown for each category. The

numbers in this column coincide with the numbers

n u m b e r of task-hours specified by the "work time"

used in the tools and equipment column of the

f i g u r e represents the average time required to re-

M A C . The numbers indicate the applicable tool or

s t o r e an item (assembly, subassembly, component,

t e s t equipment for the maintenance functions.

module, end item or system) to a serviceable condi-

b . M a i n t e n a n c e C a t e g o r y . The codes in this col-

t i o n under typical field operating conditions. This

u m n indicate the maintenance category allocated

time includes preparation time, troubleshooting

the tool or test equipment.

t i m e , and quality assurance/quality control time in

c. Nomenclature. This column lists the noun

a d d i t i o n to the time required to perform the spe-

name and nomenclature of the tools and test

cific tasks identified for the maintenance functions

equipment required to perform the maintenance

authorized in the maintenance allocation chart.

functions.

Subcolumns of column 4 are as follows:

National/NATO Stock Number. This column

C-Operator/Crew

lists

the National/NATO stock number of the spe-

O-Organizational

cific

tool or test equipment.

F-Direct Support

Tool Number. This column lists the manufac-

H-General Support

turer's part number of the tool followed by the

D-Depot

F e d e r a l Supply Code for manufacturers (5-digit) in

e. Column 5, Tools and Equipment. C o l u m n 5

parentheses.

specifies by code, those common tool sets (not indi-

v i d u a l tools) and special tools, test, and support

C-5. Remarks (Sect. IV)

equipment required to perform the designated

function.

Not applicable.