SECTION I INTRODUCTION - TM-11-5905-200-24P0002

SECTION I

INTRODUCTION

PD-

Support item, excluding support equipment,

1-1. Scope

procured for initial issue or outfitting and stocked

only for subsequent or additional initial issues or

This manual lists repair parts and special tools required

outfittings.

Not subject to automatic

for the performance of organizational, direct support,

replenishment.

general support, and depot maintenance of the TS-402/U

PE- Support equipment procured and stocked for initial

and TS-402/U.

The PCCN for the equipment is

issue or outfitting to specified maintenance

GTEAAB for all models.

repair activities.

PF- Support equipment which will not be stocked but

1-2. General

which will be centrally procured on demand.

PG- Item procured and stocked to provide for sustained

This repair parts and special tools list is divided into the

support for the life of the equipment. It is applied

following sections:

to an item peculiar to the equipment which

Prescribed Load Allowance (PLA)-Section II.

because of probable discontinuance or

Not applicable.

shutdown of production facilities would prove

Repair Parts List-Section III. Not applicable.

uneconomical to reproduce at a later time.

Special Tools, Test and Support Equipment-

KD - An item of depot overhaul/repair kit and not

Section IV. Not applicable.

purchased separately. Depot kit defined as a kit

Repair Parts List-Section V. A list of repair

that provides items required at the time of

parts authorized for the performance of maintenance at

overhaul or repair.

the direct support, general support, and depot level.

KF- An item of a maintenance kit and not purchased

Special Tools, Test and Support Equipment-

separately. Maintenance kit defined as a kit that

Section VI. Not applicable.

provides an item that can be replaced at

Index-Federal Stock Number and Reference

organizational or direct support or general

Number Cross-Reference to Figure and Item Number-

support levels of maintenance.

Section VII. A list, in ascending numerical sequence, of

KB - Item included in both a depot overhaul/repair kit and

all Federal stock numbers appearing in the listings,

a maintenance kit.

followed by a list, in alphameric sequence, of all

MO- Item to be manufactured or fabricated at

reference numbers appearing in the listings. Federal

organizational level.

stock number and reference numbers are cross-

MF- Item to be manufactured or fabricated at direct

referenced to each illustration figure and item number or

support maintenance level.

reference designation appearance.

MH-Item to be manufactured or fabricated at general

support maintenance level.

1-3. Explanation of Columns

MD-Item to be manufactured or fabricated at depot

maintenance level.

The following provides an explanation of columns found

AO- Item to be assembled at organizational level.

in the tabular list.

AF- Item to be assembled at direct support maintenance

Source, Maintenance, and Recoverability

level.

Codes (SMR).

AH- Item to be assembled at general support

Source code. Indicates the manner

(1)

maintenance level.

of acquiring support items for maintenance, repair, or

AD- Item to be assembled at depot maintenance level.

over-haul of end items. Source codes are-

XA- Item is not procured or stocked because the

requirements for the item will result in the

Code

Explanation

replacement of the next higher assembly.

PA - Item procured and stocked for anticipated or known

XB- Item is not procured or stocked. If not available

usage.

through salvage, requisition.

PB- Item procured and stocked for insurance purposes

XC-Installation drawing, diagram instruction sheet, field

because essentiality dictates that a minimum

service drawing, that is identified by

quantity be available in the supply systems.

manufacturers' part number.

PC - Item procured and stocked and which otherwise

XD- Support items can be requisitioned with justification.

would be coded PA except that it is deteriorative

in nature.