External Connections

TM 11-5895-1179-13 * EE132-EA-OMP-010/E106 KY883 * TO 31S1-2GSC-161

CAUTION

When cutting the tape on the fiberboard container, do not allow the cutting tool to penetrate the

container and damage the encoder-decoder or the manual.

(1)

Observing the caution above, cut or tear the sealing tape from the top of the fiberboard container.

(2)

Open the fiberboard container and remove the upper plastic foam cushion.

(3)

Remove the Operator's, Organizational, and Direct Support Maintenance Manual and the encoder-decoder

from the fiber- board container. If the encoder-decoder is not to be inspected immediately, store the encoder-

decoder and the Operator's, Organizational, and Direct Support Maintenance Manual in a safe, clean, dry

place pending inspection. To repack equipment for shipment or limited storage, reverse the preceding

instructions.

b. Checking Unpacked equipment. After unpacking the equipment, the encoder-decoder should be checked

according to the following procedures:

(1) Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report as

(2) Check the equipment against the packing list shipped with the equipment to see if the shipment is complete.

Report all discrepancies in accordance with the instructions in paragraph 1-3.

(3) Check to see whether the equipment has been modified. Equipment which has been modified will have the

MWO number near the nomenclature plate. Check also to see whether all currently applicable MWOs have been applied.

MWOs applicable to the equipment are listed in DA Pam 310-1.

c. Tools. Test Equipment. and Materials Required for Installation. Tools required for installation of the encoder-decoder

are contained in Tool Kit, Electronic Equipment TK-100/G (NSN 5180-00-605-0079). No test equipment is required for

installation of the equipment.

d. Installation Instructions. Mount the encoder-decoder in its assigned position

in accordance with the specific

installation instructions for the shelter or vehicle in which it is to be used.

2-5. External Connections

The reference designations, titles, and mating connectors for each interface connector are listed in table 2-3.

2-9