|
|
CHAPTER 1
INTRODUCTION
Section I. GENERAL.
1. Scope
2. Forms and Records
a. Unsatisfactory Equipment Reports.
a. This manual contains information on the
(1) Fill out and forward DA Form 468 (Unsatisfactory
installation, operation, and operator's maintenance of
Equipment Report) to Commanding Officer, U.
Processing Equipment PH-406 and Photographic
S. Army Signal Equipment Support Agency, Fort
Processing Unit ES-20(1).
Monmouth, N. J., as prescribed in AR 700-38.
b. Two appendixes are included in this manual:
(2) Fill out and forward AFTO Form 29
Appendix I, References.
(Unsatisfactory Report) to Commander, Air
Materiel Command, Wright-Patterson Air Force
Lists.
Base, Ohio, as prescribed in AF TO OO0 35D-
c. The Maintenance Allocation Chart is located
54.
in appendix II of TM 11-405-25.
b. Damaged or Improper Shipment. Fill out and
d. Official nomenclature followed by (*) is used
forward DD Form 6 (Report of Damaged or Improper
to indicate all models of the equipment covered in this
Shipment) as prescribed in AR 700-58 (Army) and AFR
manual. Thus, Printer PH-129(*) represents Printers
71-4 (Air Force).
PH-129, PH-129-A, and PH-129-B; Printer PH-639 (*)/TF
c. Preventive Maintenance Form. Prepare DA
represents Printer PH-639/TF and PH-639A/TF; and
Interval Timer PH-426-(*) represents Interval Timers PH-
for Signal Equipment (Photographic Developer,
426, PH-426-A, and PH-426-C.
Projector, Dryer, Contact and Projection Printer)) in
e. Forward all comments on this publication
accordance with the instructions on page 1 of the form.
direct to Commanding Officer, U. S. Army Signal
Publications Agency, Fort Monmouth, N.
J.
Section II. DESCRIPTION AND DATA 3.
in producing and processing projection prints from
3. Purpose and Use
processed film. Either system processes cut film (up to
4 by 5 inches) and roll film (35 millimeter). The
Processing Equipment PH-406 an Photographic
equipment is portable and is intended primarily for field
Film Processing Unit ES-20(1) are used in processing
use.
exposed
still-camera
film
and
4. Technical Characteristics
a. Major Components.
Printer PH-129-(*), Printer PH-639(*)/TF, or Photographic Projective Printer EN-16(1):
Type.........................................................
Projection.
Negative size ...........................................
35-mm film and cut film up to 4 x 5 inches.
Enlargements:
35-mm negatives .....................................
16 diameters maximum.
4- by 5-inch negatives .............................
4 diameters maximum.
AGO 5894A
3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |