DISASSEMBLY AND REASSEMBLY OF CLUTCH AND BRAKE ASSEMBLY - Continued

TM 11-3895-209-14

5-12. DISASSEMBLY AND REASSEMBLY OF JACKSHAFT ASSEMBLY - Continued

F Install the two collars (12) and (19) on the shaft. Position the shaft so

that it is centered in length through the bearings. Push the collars

firmly against the bearings, and tighten the socket-head setscrews

(11) and (18) in the collars.

G Install the jackshaft pulley (10) on the shaft with

the hub of the pulley toward the housing.

H Aline the slot in the jackshaft pulley (10) with the

groove in the shaft, and insert the key (9).

I Position the jackshaft pulley so that the outer

edge of the pulley is flush with the end of the shaft,

and tighten the two socket-head setscrews (8) in

the hub of the pulley.

J Install the timing pulley (17) on the shaft, with the

three clamp screws facing toward the housing.

K Aline the slot in the timing pulley with the groove

in the shaft, and insert the key (16). Aline the outer

edge of the pulley flush with the end of the shaft,

and tighten the three socket-head clamp screws

in the hub of the timing pulley.

5-25