DISASSEMBLY AND REASSEMBLY OF BEARING HOUSING ASSEMBLY- Continued

TM 11-3895-209-14

5-10. DISASSEMBLY AND REASSEMBLY OF BEARING HOUSING ASSEMBLY- Continued

REASSEMBLY

A Install the hub locking device assembly (18) with bolts (23) on the bearing housing (22).

B Install the shaft retaining ring (15) in the groove nearest the larger end of the reel support shaft

(17).

C Install the ball bearing (16) on the reel support shaft (17).

D Install the shaft retaining ring (14) in the second groove in the reel support shaft.

E Insert the ball bearing (13) into the longer end of the bearing housing (22), and install the hous-

ing retaining ring (11).

F Insert the reel support shaft and its ball bearing into the shorter end of the bearing housing

until the end of the reel support shaft extends through the other ball bearing.

G Install the shaft retaining ring (12) in the groove at the end of the reel support shaft.

H Aline the holes in the collar (10) with the threaded holes in the end of the reel support shaft), and

install and tighten the two socket-head capscrews (9).

Assemble the lock bolt assembly; screw the locknut (7) onto the lock bolt (8) and install the

E-ring (6).

J Insert the latch spring (4) and the ball bearing (3) into the correct hole in the collar (1 O) in both

the upper and lower unit.

K Insert the lock bolt assembly into the slot in the collar, and aline the bolt holes. Install and

tighten the socket-head capscrew (1).

L Insert the locking plate (2) into the slot in the collar, and aline the bolt holes. Install and tighten

the socket-head capscrew (1).

M Place the bearing housing assembly (22) on the frame of the RL-207(*)/G and aline the bolt

holes in the bearing housing with the mounting holes in the frame. Install and tighten the four

bolts (19), lock washers (20), and nuts (21).

8-8