|
|
TO 14P3-5-61
TM 10-8475-202-13
f. Close entrance slide fastener, making sure
slider is in full closed position (see Figure 2-7).
Note
Pulling neck seal away from the neck and crouching
prior to jumping will aid in expelling excess air and
Note
reducing coverall bulkiness.
Excessive force is not required to close entrance
slide fastener if proper alignment of scoops prior to
h. Jump into water feet first with arms close to the
slider movement is assured and fastener lips are
sides of the body or brought together over the head.
lubricated. The slider shall be pulled in the direction
of the long axis of the fastener and not at an angle.
The tying of a square knot in end of slider pull tab
i. Gloves normally worn during flight should be
provides a loop to enhance leverage when closing
used until after boarding the life raft to keep the hands
slide fastener.
dry and warm. The gloves and hood found in coverall
pockets can then be readily donned (see Figures 2-10
g. Adjust coverall waist band and boot ankle straps
and 2-11 ).
to take up coverall fullness (see Figures 2-8 and 2-9).
2-2 Change 12
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |