SPECIAL INFORMATION. - TM-10-3950-206-20P0010

TM10-3950-206-20P

Government activity which controls the design and

g. U/M (Column (7)). The Unit of Measure (U/M)

indicates the measure (e.g., foot, gallon, pound) or count

characteristic of item by means of its engineering

(e.g., each, dozen, gross) of a listed item. A two-

drawings, specifications standards, and inspection

character alpha code (e.g., FT, GL, LB, EA, DZ, GR)

requirements to identify an item or range of items.

appears in this column to indicate the measure or count.

If the U/M code appearing in this column differs from the

NOTE: When you use an NSN to requisition

Unit of Issue (U/I) code listed in the Army Master Data

item, the item you receive may have a different number

File (AMDF), request the lowest U/I that will satisfy your

from the part ordered, but go ahead and use or furnish it

needs.

as the replacement part.

h. QTY INC IN UNIT (Column (8)). The

f. DESCRIPTION (Column (6)).

This column

Quantity Incorporated in Unit (QTY INC IN UNIT)

includes the following information:

indicates the quantity of the item used in the breakout

shown on the illustration figure, which is prepared for a

(1) The Federal item name and, when required a

functional group, subfunctional group, or an assembly. A

minimum description to identify the item.

"V" appearing in this column in lieu of a quantity indicates

that no specific quantity is applicable (e.g., shims,

(2)

The

physical

security

classification.

spacers).

applicable.

4. SPECIAL INFORMATION.

(3) Items that are included in kits and set.listed

below the name of the kit or set.

a. Bulk materials required to manufacture items

are listed in the Bulk Material Group of this manual.

(4)

Spare/repair parts that make up an

NSN's for bulk materials are also referenced in the

assembled item are listed immediately following the

description column of the line item entry for the item to

assembled item line entry. If the first item of a figure

be manufactured/fabricated. Detailed manufacturing

indented, the assembly appears as the last item in

instructions for items source coded to be manufactured

previous figure.

or fabricated are found in TM10-3950-206-12.

(5) NSN's for bulk materials are referenced the

b. Detailed assembly instructions for items

description column in the line item entry for the item to

source coded to be assembled from component

be manufactured/fabricated.

spare/repair parts are found in TM10-3950-206-12. Items

that make up the assembly are listed immediately

(6) When the part to be used differs between

following the assembled item entry.

serial numbers of the same model, the effective numbers

are shown as the last line of the description.

c. Line item entries for repair parts kits and sets

appear as the last entries in the repair parts listing for the

(7) The USABLE ON CODE. Not applicable.

figure in which their parts are listed as repair parts.

(8) In the Special Tools List section, the Basis Of

d. Items which have the word BULK in the figure

Issue (BOI) appears as the last line(s) in the for each

number column will have an index number shown in the

special tool, special TMDE, and other special support

item number column. This index number is furnished for

equipment.

When density of equipment supported

use as a cross-reference between the National Stock

exceeds density spread indicated in the basis of issue,

Number/Part Number Index and the Bulk Material List in

the total authorization is increased proportionately.

Section II.