Section IV. LEECE-NEVILLE MODEL R0015027RC

TB 9-2920-225-34-1

Figure 3-7. 0pen viewmodel 5027RB.

LEECE-NEVILLE MODEL R0015027RC

Section IV.

3-8. General. Figure 38 is an exploded view of

probe on TP2. Meter should read low ohms (hun-

dreds ).

the regulator, listing the major subassemblies.

Figure 39 is a plan view of the box subassembly

( 3 ) Reverse probes in (2) above. Meter

and an underside view of the cover subassembly,

should read high ohms (thousands).

showing the interconnect wiring. Figure 310 is a

(4) If other readings are obtained in (2) or

plan view of the box and an underside view of the

(3), replace diode D1.

cover showing the components and test points.

(5) Place positive probe on TP2 and negative

There are 10 test points. Figure 311 is an electri-

probe on pin C of connector J2. Meter should read

cal schematic diagram of the regulator circuit.

approximately 55 ohms.

(6) If another reading is obtained, remove

3-9. Checkout and Repair.

and replace both the relay and diode D2.

a. Diode D2 and Relay (see jigs. 38 through

b. Resistor R1. Place ohmmeter probes across

311) (voltage off).

resistor R1 (see figs. 3-9, 3-10, and 311 ), Meter

should read approximately 0.4 ohms.

(1) Place positive probe of ohmmeter to pin

F of connector J2 and negative probe on TP1.

c. Voltage Adjustment Rheostat.

Meter should read 0 ohms.

(1) Remove voltage adjustment access screw

from cover of regulator.

(2) Place positive probe on TP1 and negative

3-9