Perform resistance checks of the generator per chart 1.

TB 9-2350-257-20-1

STEP 13

a. If generator checks per chart 1, proceed to step

b. If generator does not check per chart 1, proceed

CAUTION

Prior to performing a resistance check of the generator, discharge the radio interference suppressor

(REASON Voltage may be present because the suppressor is attached to Circuit 2 Damage to the

multimeter could occur with the selector switch In the ohms position.) Use an insulated piece of wire,

place one end on pin F or B and ground the other end of the wire to the vehicle chassis. This procedure

may have to be repeated several times to completely drain the suppressor. Make a final voltage check,

when no voltage is indicated it is safe to perform the resistance check.

CHART I

Use only the RX1 scale for these measurements.

Generator

Bulkhead

Harness

Resistance

Connector

From (+)

To(-)

Ohms

11655547

GROUND

F (Circuit 2)

Infinite

11655547

F (Circuit 2)

GROUND

30-45

11655547

GROUND

B (Circuit 2)

Infinite

11655547

B (Circuit 2)

GROUND

30-45