SECTION II. DESCRIPTION, FABRICATION AND OPERATION

SECTION II. DESCRIPTION, FABRICATION AND OPERATION

3. Physical Description. a. The primary design

b. The 110-volt motor (fig. 1) specification re-

quires one horsepower minimum output at a speed

criteria dictated the use of those components and

of approximately 1800 rpm at less than 10 am-

materials readi]y available in the field. Only

peres.

those connectors which are normally used with

the components for which tile test unit was de-

C . A list of parts and common hardware re-

quired to fabricate tile tester- is shown in table 2.

signed are included.