Assembly.

TB 9-2300-378-14

(d) Weld rod to edge of washer on other side.

(e) Repeat steps (a) through (d) above for other end of chain.

Plate. Using aluminum plate, fabricate plate as follows:

(5)

(a) Cutout aluminum plate and lay out holes (view D).

( b ) Cutout center hole.

(d) Use a 13/64 inch drill to bore six holes through plate and positioned hose

assembly.

(e) Remove hose assembly and tap the newly drilled holes in hose assembly using

a 1/4-20 UNC tap.

(f) Enlarge six drilled holes in aluminum plate to 17/64 inch diameter.

(g) Drill four holes 3/8 inch diameter.

Hose Assembly Modification.

(6)

Modify hose assembly as follows:

NOTE

Remove parts from one end of hose assembly only.

(a) Remove band clamp from end of hose assembly (view E).

(b) Use punch to remove six (6) cold rolled pins.

( c ) Remove clamp fingers.

(d) Remove preformed packing.

Assembly.

(7)

Assemble the ground hop filter as follows:

A t t a c h modified hose assembly to plate using rubber gasket, six 1/4-20

(a)

screws and six flat washers.

Lockwire six screws.

(b)

WARNING

Loose

S c r e w s must be lockwired to prevent loosening.

screws could fall out and be drawn into the turbocharger,

causing damage to equipment and injury to personnel.

Center seal end of filter against aluminum plate.

(c)

4-24