The following questions are multiple choice type.

TB 600-2

A driver may use gasoline to clean his vehicle engine.

A driver is responsible that his vehicle tools are always present, complete, and in serviceable condition.

A driver should always know his destination and route before leaving the motor park.

10.

Before stopping, a vehicle engine should be cooled by idling.

11.

Permitting vehicles to stand overnight with low fuel levels will allow condensation, resulting in water in the fuel.

12.

Driver does not need to check instruments after engine is warmed up.

13.

During freezing weather, vehicles should be parked on planks.

14.

Brakes should be applied intermittently when used in descending a long grade.

15.

Instructions on lubrication charts should be strictly adhered to when servicing a vehicle.

16.

If a tire is cut, exposing the bo dy plies, it should be removed and repaired before further damage occurs.

17.

Scarifier teeth should be removed and placed in storage location when not in actual use.

18.

If engine does not start after holding button in for 30 seconds, you can hold it fo r 30 seconds more immediately.

19.

Air receiver tanks must be drained daily to prevent condensation from entering air brake system.

20.

Always operate the unit in the highest gear possible and at full throttle.

Section III. SUGGESTED TEST QUESTIONS FOR WHEELED OR TRACK TYPE

TRACTORS, FRONT LOADERS, MOTORIZED SCRAPERS,

ROLLERS AND SWEEPERS

A. Answer these questions by "True" or "False".

1. Engine should be operated at full throttle during warmup period.

2. Transmission should be in "neutral" position when engine is started.

3. If oil pressure gauge shows zero, it should be reported after reaching motor park.

4. Driver should always disengage clutch while descending grades.

5. Water pump grease is osluble in water.

6. Any member of the US Army is authorized to drive a military vehicle.

7. A driver may use gasoline to clean his vehicle engine.

8. A driver is responsible that his vehicle tools are always present, complete, and in serviceable condition.

9. A driver should always know his destination and route before leaving the motor park.

10. Before stopping, a vehicle engine should be cooled by idling.

11. Permitting vehicles to stand overnight with low fuel levels, will allow condensation, resulting in water in the fuel.

12. Driver does not nee d to check instruments after engine is warmed up.

13. During freezing weather, vehicles should be parked on planks or dunnage.

14. Brakes should be applied intermittently when used in descending a long grade.

15. Instructions on lubrication charts should be strictly adhered to when servicing a vehicle.

B. The following questions are multiple choice type.

16. When loading earth moving scoops or bowls:

a. Make a thin long cut.

b. Make a deep cut till engine lugs, then taper off on cut.

17. When traveling empty from dump to fill locations:

a. Use highest gear position without overloading the prime mover engine.

b. Use lower gear positions and carry bowl high.

18. If possible, arrange the work so a scraper can be loaded:

a. Down hill and in direction of fill.

b. Down hill and away from direction of fill.

19. When there is a choice of routes traveling from cut to fill:

a. Always take long route to save time by utilizing higher speed.

b. Take short, steeper route using low gear to save maintenance cost on trucks, rollers, bearings, etc.

20. If a tire is cut, exposing the cords of the body plies: a. Disregard it and continue operating unit if tire does not go

flat.

B-2