SSS-013-003-3 Power Cable

SB 740-91-01

10. SSS-013-003-3 Power Cable

a. Materials Required.

(1)

Cable, CC14UO-22P, 3.5 feet

(2)

Terminal lugs MS-25036-53, 4 each.

b. Construction.

(1)

Mark cable SSS-013-003-3 Power Cable

(2)

Mark either end of red wire positive "+"

(3)

Mark either end of black wire negative

(4)

Strip each end of wire 0.1875 inch. Securely crimp a terminal lug to each

stripped end of wire.

Diagrams. Not applicable.

11. SSS-013-003-4 Test Cable No. 2.

a. Materials Required. This cable is identical to SSS-013-003-2 Test Cable No.

1 except as follows:

(1)

Connector plug MWIOM(M)D17, 18 pin 5835-00-815-2325 instead of U-344/VRC

(2)

All wire No. 14 AWG, terminal lugs MS-25036-49, 18 each

(3)

No terminal lugs MS-25036-53 required.

b. Construction. Same as SSS-013-003-2 (paragraph 9.b), except for marking of cable and requirement for the

two jumper wires. Mark this cable SSS-013-003-4 Test Cable No. 2.

c. Diagrams. Use those for SSS-013-003-2 (paragraph 9.c), except different connector.

12. SSS-013-003-5 Test Cable No. 3.

a. Materials Required.

(1)

U-229/U connector, 5 pin, 1 each

(2)

Terminal board, plastic, type PBE, 0.25 x 2.5 x 3 inches

(3)

Nut MS-85649-286, 10 each

(4)

Washer MS-15795-907, 5 each

(5)

Screw, Type I, Style 8s, brass 8-32UNC-28 x 0.75 inches long, 5 each

(6)

Terminal lug MS-25036-53, 5 each

(7)

Sleeving AWG, size No. 5

(8)

Twine, type P, class 2, waxed

(9)

Wire, No. 14 AWG, approximately 3 feet of different colors.

b. Construction.

(1)

Mark cable SSS-013-OOpOO003-5 Test Cable No. 3

(2)

Mark terminal letters on terminal board

(3)

For terminal board construction see paragraph 9.c. Make for 5 terminals

instead of 18

(4)

Overall construction is similar to that stated in paragraph 9.b

B-28