Assembly - (cont.) - TM-5-4930-233-140358

TM 5-4930-233-14

TM 4930-14/1

LUBE TANK ASSEMBLY

5-18. LOW PRESSURE PUMP - (Cont.)

Assembly - (cont.)

(18) Install plug (32).

(19) Install gasket (31) and valve seat (30).

(20) Lubricate sides of slide valve (29) that contact valve fluid and plug assemblies (27).

(21) Install slide valve (29), two stops (28), two valve guide and plug assemblies (27) and four screws (26).

(22) Coat shuttle (19) (including inside bore), plungers (24) and toggles (25) with lubricant.

(23) Install two toggles (25), two plungers (24) and shuttle (19). Be sure that larger bore of shuttle is facing

upwards.

(24) Install preformed packing (23) and position valve body and stop assembly (22) on eight tie rods. Install eight

nuts (21).

(25) Lift trip rod as shown, apply sealant and install nut (20).

(26) Install preformed packing (18), adapter (17) and eyebolt (16).

(27) Install spring (15), washer (14) and cylinder (13) into cap (10). Be sure that top of cylinder is flush with or

below edge of cap. Repeat for other cap.

(28) Coat two springs (12) with lubricant.

(29) Install two springs (12), two gaskets (11), two caps (10) and two set screws (9).

(30) Place ounce (7.4 ml) of oil into air cavity before installing preformed packing (8), adapter (7) and

four screws (6).

5-99