 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4930-233-14
TM 4930-14/1
AXLE ASSEMBLY
4-58. BRAKE ASSEMBLY - INSPECT/ADJUST/BLEED/REPLACE/REPAIR (Cont.)
f.
Repair
WARNING
Clean all parts in a well ventilated area. Avoid inhaling solvent fumes and prolonged exposure of
the skin to cleaning solvent. Failure to do so can cause severe injury or death. Do not use near
flame or excessive heat. Flash point of solvent is 100 to 138 (38 to 59 ).
F
F
C
C
(1)
Clean all parts of grease and dirt using dry cleaning solvent.
(2)
Use a wire brush to remove all corrosion.
(3)
Inspect back plate for cracks, galling or wear. Replace if defective.
(4)
Inspect hydraulic cylinder for leakage or corrosion. Replace if defective.
(5)
Measure brake linings. If thickness is not 1/8 inch (3.175 mm), replace. If linings are cracked, replace.
(6)
Replace adjustment screw if corroded or worn.
(7)
Inspect bearings in accordance with TM 9-214.
(8)
Discard springs (20) and cups (19).
4-175
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals