 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4930-233-14
TM 4930-14/1
WIRING HARNESS OR TRAILER ELECTRICAL
4-53. JUNCTION BOX - TEST/REPLACE - (Cont.)
b.
Removal
(1)
Insure that intervehicular connector is disconnected.
(2)
Open junction box (1) loosen screws (2) and slide latches (3) out of the way.
(3)
Tag and disconnect six 12 volt intervehicular electrical leads (4) by loosening nuts (5) and screw (6).
(4)
Tag and disconnect six 24 volt intervehicular electrical leads (7) by loosening nuts (5) and screw (6).
(5)
Tag and disconnect five trailer harness electrical leads (8) by loosening screws (6).
(6)
Remove three nuts (9), three washers (10), three grommets (11), trailer electrical harness (12), 12
volt intervehicular cable (13) and 24 volt intervehicular cable (14).
(7)
Remove eight nuts (15), four lockwashers (16), four screws (17) and junction box (1).
c.
Installation
(1)
Install junction box (1), four screws (17), four lockwashers (16) and eight nuts (15).
(2)
Slide three nuts (9), three washers (10) and three grommets (11) onto trailer electrical harness (12),
12 volt intervehicular cable (13) and 24 volt intervehicular cable (14).
(3)
Install trailer electrical harness (12), 12 volt intervehicular cable (13) and 24 volt intervehicular cable
(14) into junction box (1) and tighten nuts (9).
(4)
Connect five trailer electrical leads (8) and remove tags.
(5)
Connect six 24 volt intervehicular electrical leads (7) and remove tags.
(6)
Connect six 12 volt intervehicular electrical leads (4) and remove tags.
(7)
Close junction box (1) and tighten latches (3) by tightening screws (2).
Change 1 4-156
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals