CHAPTER 4 UNIT MAINTENANCE INSTRUCTIONS

TM 5-4930-233-14

TM 4930-14/1

Chapter 4

UNIT MAINTENANCE INSTRUCTIONS

Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

4-1.

COMMON TOOLS AND EQUIPMENT

For authorized common tools and equipment refer to the Modified Table of Organization and Equipment

(MTOE) applicable to your unit.

4-2.

SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

No special tools or equipment is required to maintain the lube and servicing unit.

4-3.

REPAIR PARTS

Repair parts are listed and illustrated in the repair parts and special tools list (TM 5-4930-233-24P) covering

Unit, Direct Support and General Support maintenance for this equipment.

Section II. SERVICE UPON RECEIPT

4-4.

CHECK UNPACKED EQUIPMENT

Remove any metal strapping, plywood, tapes, seals, wrapping paper or any other shipping material.

WARNING

Clean all parts in a well ventilated area. Avoid inhaling solvent fumes

and prolonged exposure of the skin to cleaning solvent. Failure to do

so can cause severe injury or DEATH. Do not use near flame or

excessive heat. Flash point of solvent is 100 to 138 (38 to 59 ).

If any exterior parts are coated with rust preventative compound, remove it with cleaning solvent (Item

Inspect the equipment for damage incurred during shipping. If the equipment has been damaged,

report the damage on DD Form 6 Packaging Improvement Report.

Check the equipment against the packing slip to see if the shipment is complete. Report all

discrepancies in accordance with the instructions of DA PAM 738-750. Marine Corps users refer to

MC04430.3.

Check to see whether the equipment has been modified.

4-1