 |
|||
|
|
|||
|
Page Title:
By-Pass of Hot Gas By-Pass System |
|
||
| ||||||||||
|
|
 TM 5-4120-394-BD
a. General Information:
(1) Limitations-None.
(2) Personnel/Time Required.
1 Soldier/0.3 hours.
(3) Materials/Tools.
Wire (Appendix C)
Tape, Electrical (Appendix C, Item 10)
Crimping Tool (Appendix B, Item 2)
b. Procedural Steps:
(1) Locate wires emerging from thermostat.
(2) Cut both wires, leaving enough wire remaining to reattach later.
(3) Remove approximately one inch of insulation from each wire NOT attached to thermostat.
(4) Twist exposed wire together.
(5) Tape twisted connection covering exposed wire.
(6) Resume operations.
NOTE
When the mission is completed, repair using standard maintenance procedures.
(7) Record BDAR action taken.
3-9/(3-10 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals