INSTRUMENTS AND CONTROLS

INSTRUENTS AND CONTROLS

200 /93 , transmission shift lever in NEUT RAL position

It is essential that the operator become thoroughly familiar

with all instruments and controls before operating the

and engine operating with no load at governed speed.

machine. The terms "right hand" and "left hand" when

refer- ring to a machine component are determined by

TRANSMISSION OIL TEMPERATURE GAUGE should

sitting in the operator's seat and facing toward front of

machine.

temperature approaches upper limit, shift to a lower

operating speed range. Transmission and torque converter

It is a good practice to observe gauges frequently. during

oil temperature must not exceed 250 121 . If

machine operation. Do not operate machine if gauges are

overheating persists, shut down and determine cause.

not functioning properly.

AMMETER should deflect slightly toward the negative

during starting. With engine running and fully charged

batteries, the ammeter should register at zero. A positive

reading will occur if batteries are not fully charged. If a

negative reading occurs, the red ammeter warning light will

turn on. The ammeter warning light is activated if the

engine is not running and the key is in the ACCESSORY or

RUN position. The warning light will remain on after

starting with engine at idle until throttle is depressed. If the

ammeter warning light re- mains on, the operator should

refer to TROUBLE SHOOTING GUIDE to correct mal-

function.

Console Gauges

INSTRUMENTS:

ENGINE WATER TEMPERATURE GAUGE should

operating conditions. Engine coolant temperature must

never exceed 200 /93 . If gauge reading exceeds

195 /91 shut down and determine cause of overheating.

ENGINE OIL PRESSURE GAUGE while engine Is at Idle

(600 RPM) should read 10 to 25 psi (69 to 173 kPal 0,7 to

1,8 kg I sq cm), With engine at rated speed (2800 RPM),

gauge readings should be 45 to 75 psi (310 to 517 kPa

13,2 to 5,3 kg/sq cm). 011 pressure readings should be

made while engine Is warm.

Warning: If gauge falls to register within 15 seconds of

starting, stop engine Immediately and determine cause.

Control Levers

CONVERTER "OUT" OIL PRESSURE GAUGE should

transmission oil at 200 /93 , engine at 2000 RPM and

trans- mission gear shift lever in NEUTRAL position

Maximum pressure is not to exceed 70 psi (482 kPa/4,9

kg/sq cm) with transmission oil at

Rev. 760501

K300

200 2.-1