SEPARATION OF GOVERNOR FROM FUEL INJECTION PUMP HOUSING

3208 INDUSTRIAL AND MARINE ENGINES

DISASSEMBLY AND ASSEMBLY

FUEL INJECTION PUMP HOUSING AND GOVERNOR

9. Remove the thrust collar (11) from the shaft.

10. Remove the cover (10) from the pump housing.

11. Loosen the two bolts (13) that hold the

torque spring assembly (12) and remove it

from the pump-housing.

12. Remove the pin (15) from the pump

housing.

13. Remove the screw (14) and the nut (16)

from the pump housing.

14. Remove the ring that holds the lever and

remove the lever (18) from the dowel (17).

15. Remove the dowel (17) from the pump

housing.

NOTE: Dowel does not need to be removed unless

camshaft is to be removed.

CAUTION : Pull on the shield only a small amount

in each location so it will not have distortion or

damage. A damaged shield must be replaced.

16. Remove the shield (19) from the camshaft

with tool (B).