Table 5-2. Pre-Test Inspection

TM 32-5865-069-24&P

Pre-Test Inspection - Continued

Table 5-2.

Assembly/

Inspection

Normal

method

Procedure

indication

component

Visual

CCA A11

Inspect for discolored,

a thru c must be

free of defects.

loose, broken or burned

components and connections.

Inspect for cold solder

joints, and excessive

so1der.

c. Inspect board for cracks,

chips and breaks.

(2) Start ATESP/UUT testing by entering the following command at the

TEST (the TPT number from table 5-l)PV1 ret

TEST 5051600PV1 ret

TEST 5052332PV1 ret

examples -

etc.

(3) Based on the program entry points, described in table 5-1, select and

execute one of the following options:

NOTE

The first entry point must be used for the first test of the UUT.

(a) If the first entry point is to be used, press PROCEED.

(b) Enter the appropriate entry point; press RETURN.

MARNING

HIGH VOLTAGES are used during test. Extreme caution should be exer-

cised. These HIGH VOLTAGES could cause death.

(4) Follow the instructions as they appear on the VDT until the program is

complete.

5-19