APPENDIX B COMPONENTS OF END ITEM LIST - TM-32-5410-215-14-P0049

TM 32-5410-215-14&P

APPENDIX B

COMPONENTS OF END ITEM LIST

Section I. INTRODUCTION

c. Part Number. Indicates the primary number

B-1 SCOPE. This appendix lists integral components of

used by the manufacturer, which controls the design and

and Basic Issue Items (BII) for Repair Parts Stowage

characteristics of the item by means of its engineering

Facilities AN/USM-378, AN/USM-379 and AN/USM-380

drawings, specifications, standards, and inspection

(RPSF) to help you inventory items required for safe and

requirements to identify an item or range of items.

efficient operation.

d. Description. Indicates the Federal item name

B-2 GENERAL. This Components of End Item List is

and, if required, a minimum description to identify the

divided into the following sections:

item.

a. Section II. Integral Components of the End Item.

e. Location. The physical location of each item

These items, when assembled, comprise the RPSF and

listed is given in this column. The lists are designed to

must accompany it whenever it is transferred or turned

inventory all items in one area of the major item before

in. The illustrations will help you identify these items.

moving on to an adjacent area.

b. Section III. Basic Issue Items (BII). These are

f. Usable on Code. "USABLE ON" codes are

the minimum essential items required to place the RPSF

included to help you identify which component items are

in operation, to operate it, and to perform emergency

used on the different models. Identification of the codes

repairs. Although shipped separately packed they must

used in these lists are:

accompany the RPSF during operation and whenever it

is transferred between accountable officers.

The

Code

Application

illustrations will assist you with hard-to-identify items.

This manual is your authority to requisition replacement

Repair Parts Stowage Facility AN/USM-378

BII, based on TOE/ MTOE authorization of the end item.

Repair Parts Stowage Facility AN/USM-379

Repair Parts Stowage Facility AN/USM-380

B-3 EXPLANATION OF COLUMNS.

g. Quantity Required (Qty Req'd). This column lists

a. Illustration. This column is divided as follows:

the quantity of each item required for a complete major

item.

(1) Figure Number.

Indicates the figure

number of the illustration on which the item is shown.

h. Quantity. This column is left blank for use during

an inventory. Under the Rcv'd column, list the quantity

(2) Item Number.

The number used to

you actually receive on your major item. The Date

identify item called out in the illustration.

columns are for your use when you inventory the major

item at a later date; such as for shipment to another site.

b. National Stock Number. Indicates the National

stock number assigned to the item and which will be

used for requisitioning.

B-1