EXPLANATION OF COLUMNS (SECTIONS II AND III).

TM 3-6665-329-13&P

E-3 EXPLANATION OF COLUMNS (SECTIONS II AND III).

When the item is not used with all serial numbers of the same model, the effective serial

(6)

numbers are shown on the last line(s) of the description (before UOC).

The usable on code, when applicable (see paragraph 5, Special information).

(7)

In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in the

(8)

entry for each special tool, special TMDE and other special support equipment. When density of equipments

supported exceeds density spread indicated in the basis of issue, the total authorization is increased proportionately.

The statement "END OF FIGURE" appears just below the last item description in Column 5

(9)

for a given figure in both Section II and Section III.

QTY (Column (6)). The QTY (quantity per figure column) indicates the quantity of the item

used in the breakout shown on the illustration figure, which is prepared for a functional group, subfunctional

group, or an assembly. A "V" appearing in this column in lieu of a quantity indicates that the quantity is

variable and the quantity may vary from application to application.

E-4 EXPLANATION OF COLUMNS (SECT. IV).

NATIONAL STOCK NUMBER (NSN) INDEX.

(1) STOCK NUMBER column. This column lists the NSN by National item identification

number (NIIN) sequence. The NIIN consists of the last nine digits of the NSN

NSN

(i.e., 5305-01-674-1467). When using this column to locate an item, ignore the first 4 digits of the NSN.

NIIN

However, the complete NSN should be used when

ordering items by stock number.

(2) FIG. column. This column lists the number of the figure where the item is identified/

located. The figures are in numerical order in Section II and Section III.

(3) ITEM column. The item number identifies the item associated with the figure listed in

the adjacent FIG. column. This item is also identified by the NSN listed on the same line.

E-7