FUEL PUMP AND IGNITION DRIVE MOTOR.

2-47. FUEL PUMP AND IGNITION DRIVE MOTOR.

This task covers:

a. Disassembly

c. Reassembly

b. Repair

INITIAL SETUP

Tools and Special Tools

Equipment Condition

Automotive Maintenance and Repair Field Maintenance

Fuel pump and ignition drive motor removed from skid assembly. Refer to

Shop Equipment, Basic, Less Power (SC 4910-95-CL-A31)

paragraph 2-45 for disassembly/reassembly procedures.

LOCATION/lTEM

ACTION

REMARKS

Fuel Pump and Ignition

Drive Motor/

Machine screw (1)

Unscrew and remove four machine screws (1), four lock washers (2),

Fuel pump and ignition drive motor is shown sepa-

Lock washer (2)

cover (3), and gasket (4). Inside of opening, remove machine screw (5),

rated for illustration purposes only. The torsion helical

and lock washer (6). Remove electrical contact brush (7) by lifting torsion

Cover (3)

springs (8) and electrical contact brushes (7) will be

helical spring (8). Repeat this procedure to disassemble the electrical

Gasket (4)

removed and reinstalled through the opening under

Machine screw (5)

contact brush on the other side of the direct current motor.

cover (3).

Lock washer (6)

Electrical contact brush (7)

Torsion helical spring (8)

TM 3-4230-209-30&P