REASSEMBLY - TM-3-4230-209-30-P0210

TM 3-4230-209-30&P

2-194

2-44. FUEL HOSE ASSEMBLY AND FILLER OPENING CAP (CONT).

REMARKS

ACTION

LOCATION/lTEM

Replace authorized unserviceable parts.

Fuel Hose Assembly/

Filler Opening Cap Assembly/

Fabricate new gasket according to figure D-15.

Gasket

Fabricate new nonmetallic hose according to figure D-56.

Nonmetallic hose

Filler Opening Cap Assembly/

Decal (1) -

If removed, replace decal (1). install pipe elbow (2) and drain cock (3) into

plug assembly (4). Position grounding strip (5) on plug assembly (4) and

Pipe elbow (2)

fasten with two lock washers (6) and screws (7). Install preformed pack-

Drain cock (3)

ing (8) and gasket (9). Fabricate new gasket (9) according to figure D-15.

Plug assembly (4)

Grounding strip (5)

Lock washers (6)

Screws (7)

Preformed packing (8)

Gasket (9)

Fuel Hose Assembly/

Assemble both ends of a new rubber hose (10) using the foIlowing proce-

Rubber hose (10)

dure.

Pipe to hose straight

adapter (11)

Step 7. Place rubber hose (1 O) in vise and use a fine tooth hacksaw to

cut its ends square and to the desired length.

Step 2. Using the notches on shell of pipe to hose straight adapter (11)

as a length guide, cut through the cover down to wire braid all the

way around rubber hose (10).

Step 3. Slit the cover lengthwise from cut to end. Use screwdriver and

pliers to remove outer rubber ply to expose the bare wire braid.