REASSEMBLY (CONT) - TM-3-4230-209-30-P0159

Bracket clamps (18)

Install three bracket clamps (18) and one bracket clamp (19). Insert eight

spring pins (20), into the four posts with one spring pin above and one-

Bracket clamps (19)

Spring pins (20)

spring pin below each bracket clamp (18 and 19).

Bolts (21)

Unscrew four bolts (21) and nuts (22) and remove from four shackles (23)

Nuts (22)

and slide shackles (23) over the four projection tabs welded to the tank.

Shackles (23)

Reinstall the four bolts (21) and nuts (22) through each shackle (23),

tighten, and tack-weld the nuts to the bolts.

Pipe elbow (24)

Screw pipe elbow (24) onto the end of

metallic pipe (11). Tighten and position

so that open end of pipe elbow (24) is

pointed toward the hopper assembly

hole.

Quick disconnect

Using antiseizing tape or sealing com-

coupling half (25)

pound, wrap or coat the external

threads of quick disconnect coupling

half (25). Screw quick disconnect cou-

pling half (25) into pipe elbow (24) and

tighten.

2-143

TM 3-4230-209-30&P