REASSEMBLY - TM-3-4230-209-30-P0130

2-114

TM 3-4230-209-30&P

2-23. OFFSET VALVE AND REGULATING VALVE (CONT).

LOCATION/lTEM

ACTION

REMARKS

Offset Valve/

Replace authorized unserviceable parts

New handle should be reinstalled on the old regulating

valve to turn in.

Offset Valve/

Valve diaphragm (1)

To reassemble, place valve diaphragm (1) between halves (2 and 3) of

Be sure lubrication fitting is positioned away from

mounting bracket (5).

Valve halves (2 and 3)

regulating valve (4). Position mounting bracket (5) on top of upper half (2)

Regulating valve (4)

of regulating valve (4) with the upright in line with the inlet/outlet ports.

Mounting bracket (5)

Hexagon head cap

Aline two screw holes and insert two hexagon head cap screws (6)

through mounting bracket (5) and the offset valve. Attach two hexagon

screw (6)

plain nuts (7). Insert two hexagon head cap screws (8) through the offset

Hexagon plain nut (7)

valve and attach two hexagon plain nuts (9).

Hexagon head cap

screw (8)

Tighten four hexagon head cap screws (6 and 8) (2 ea) and four hexagon

Hexagon plain nut (9)

plain nuts (7 and 9) (2 es).

Screw lubrication fitting (10) into the offset valve and tighten.

Lubrication fitting (10)

Slide collar (11) and bevel gear (12) onto the sleeve around the shaft, then

Collar (11 )

install and tighten eight setscrews (13). Slide sleeve bearing (14) into

Bevel gear (12)

mounting bracket (5). Slide shaft extension (15) through sleeve

Setscrews (13)

bearing (14) and into bevel gear (16). Twist shaft extension (15) until the

Sleeve bearing (14)

holes aline with the holes in bevel gear (16) and insert spring pin (17).

Shaft extension (15)

Bevel gear (16)

Insert handle (18) onto the shaft, turn handle (18) to aline holes with the

Spring pin (17)

holes in shaft extension (15), and insert pin (19).

Handle (18)

Pin (19)