REASSEMBLY - TM-3-4230-209-30-P0074

TM 3-4230-209-30&P

2-58

2-17. OUTLET HOSE ASSEMBLY (CONT).

REMARKS

ACTION

LOCATION/lTEM

Outlet Hose Assembly/

Fabricate hose (1) according to figure D-26 for the lower hose reel and

Hose (1)

according to figure D-27 for the upper hose reel. Thread the strap end (2)

Strap end (2)

of each hose clamp (3) through the buckle (4) of the hose clamp (3) twice.

Hose clamps (3)

Slide two hose clamps (3) onto hose (1).

Buckle (4)

Insert stem (5) through the hole in nut (6) and then insert both into hose (1)

Stem (5)

as a unit until the rear of nut (6) is against the end of hose (1). Slide two

Nut (6)

hose clamps (3) over stem (5). Rotate the second hose clamp so that the

buckle (4) is 1800 from the first hose clamp (3) buckle to assure a better

seal. Repeat reassembly procedures for other hose clamps (3).

Insert the strap end (2) into the frame (7) of strap band clamping tool.

Frame (7)

Insert the winder (8) into the frame (7) and insert the strap end (2) through

Winder (8)

the winder (8). Use the ratchet tension wrench (9) to turn the winder (8)

Ratchet tension wrench (9)

and draw the hose clamp (3) tight.