CHAPTER 2 MAINTENANCE INSTRUCTIONS - TM-3-4230-209-30-P0016

2-0

TM 3-4230-209-30&P

CHAPTER 2

MAINTENANCE INSTRUCTIONS

CHAPTER OVERVIEW

This chapter contains general information, troubleshooting, repair of the decontaminating apparatus, and preembarkation inspection of materiel in units alerted

for overseas movement.

Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

loaded in the decontaminating apparatus pump unit in the tool drawer between

2-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and

the upper and lower hose reels and in the water heater top cover inside the tool

equipment, refer to the Modified Table of Organization and Equipment (MTOE)

carrier.

applicable to your unit.

2-3. REPAIR PARTS. Repair parts are listed and illustrated in appendix B of

2-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. Special tools

this manual.

and support equipment are listed in section Ill of appendix B of

TM 3-4230-209-10. Special tools required for intermediate direct support are

Section Il. SERVICE UPON RECEIPT

c. Check to see whether the equipment has been modified (see

2-4. CHECKING UNPACKED EQUIPMENT.

DA PAM 310-1).

a. Inspect the equipment for damage incurred during shipment. If the

equipment has been damaged, report the damage on SF 364, Report of Dis-

crepancy (ROD).

b. Check the equipment against the packing slip to see if the shipment is

complete. Report an discrepancies in accordance with the instructions of

DA PAM 738-750.

Section Ill. TROUBLESHOOTING

b. This manual cannot list all possible malfunctions that may occur, nor all

2-5. TROUBLESHOOTING PROCEDURES.

tests or inspections and corrective actions. If a malfunction is not listed (except

a. This section contains troubleshooting information for locating and cor-

when malfunction and cause are obvious) or is not corrected by listed correc-

recting most of the troubles which may develop in the decontaminating appara-

tive actions, notify your supervisor.

tus. Each malfunction for an individual component, unit, or system is followed

by a list of tests or inspections which will help you to determine corrective

2-6. SYMPTOM INDEX. Use the following symptom index for a quick refer-

actions to take. You should perform the tests/inspections and corrective

ence to symptoms covered in the troubleshooting table.

actions in the order listed.