REASSEMBLY (CONT) - TM-3-4230-209-20-P0197

Capillary tube and bulb (31)

CAUTION

Connector union (32)

Do not bend or kink the capillary tube and bulb. Any dam-

age will require replacement.

Split washers (33)

Washer (34)

Carefully route the capillary tube and bulb (31) from the selector valve in

the control box along the top of boiler unit (29).

Disassemble connector union (32) into atop and bottom half. Wrap the

end of male tapered threads with antiseizing tape before installing into top

of boiler unit (29).

Slide top half of connector union (32) so internal threads are nearest to

the bulb. Insert the bulb of capillary tube and bulb (31) just below the

lowest edge of the bottom half of connector union (32). Carefully position

two split washers (33) around the capillary tube without pinching it. Slide

the slot of (rubberlike) washer (34) around capillary tube and push it down

inside of connector union (32) lower half and against the split washer (33).

Slide two more split washers (33) around capillary tube and push them

down into connector union (32) lower half. Slide top half of connector

down onto the lower half and screw on tight.

2-165

TM 3-4230-209-20&P