REASSEMBLY - TM-3-4230-209-20-P0158

TM 3-4230-209-20&P

2-126

2-27. SKID MOUNTED DECONTAMINATING APPARATUS TANK UNIT AND REGULATING VALVE (CONT).

REMARKS

ACTION

LOCATION/lTEM

WARNING

Skid Mounted

When regulating valve is replaced, new regulating

Decontaminating Apparatus

When operating drain valve, be careful to prevent injury to

valve must be disassembled (p 2-123) and reassem-

Tank Unit And Regulating

fingers.

bled on the tank unit.

Valve/

Tape all male threads on pipe reducers, pipe elbow,

Pipe reducer (1)

Screw pipe reducer (1) on pipe nipple (2) at bottom of tank unit.

quick disconnect coupling, and pipe nipple with anti-

Pipe nipple (2)

seizing tape before installing them in female threads.

Valve bottom (3)

Screw valve bottom (3) onto pipe reducer (1).

Pipe reducer (4)

Connect pipe reducer (4) with identification

Identification plate (5)

plate (5). Install drive screws (6), pipe

Drive screws (6)

elbow (7), and quick disconnect coupling (8)

Pipe elbow (7)

in valve bottom (3).

Quick disconnect

coupling (8)

Position cross bar support (9) and U-bolt (10)

Cross bar support (9)

U-bolt (10)

so holes aline properly. Install two machine

Machine bolts (11)

bolts (11). Install two lock washers (12) and

Lock washers (12)

two hexagon plain nuts (13). Install two lock

Hexagon plain nuts (13)

washers (14) and two hexagon plain nuts (15)

Lock washers (14)

and tighten until U-bolt (10) is firmly in place.

Hexagon plain nuts (15)