REASSEMBLY - TM-3-4230-209-20-P0145

Control Panel Assembly/

Repair by replacing authorized components.

All components

Use epoxy primer and polyurethane coating to paint the

Metal surface

control panel assembly as needed (see TM 43-0139).

Cut and trim green tape to fit into the tachometer's 3800

Range mark on

to 3900 RPM range. Place on tachometer glass lens.

Tachometer

Control Panel Assembly/

NOTE

Tighten mounting hardware enough to keep gages from

rotating. Do not overtighten.

Install ammeter (1) into control panel (2) and

Ammeter (1)

fasten with bracket (3) and nuts (4). connect

Control paneI (2)

electrical leads (5).

Bracket (3)

Nuts (4)

Electrical leads (5)

Install circuit breaker (6) onto rear of control

Circuit breaker (6)

panel (2) and press boot assembly (7) onto

Boot assembly (7)

toggle of circuit breaker. Place switch

Switch shield (8)

shield (8) onto control panel (2), secure with

Lock washers (9)

lock washers (9) and machine screws (10).

Machine screws (10)

Connect electrical leads (11).

Electrical leads (11 )

TM 3-4230-209-20&P

2-113