REPAIR - TM-3-4230-209-20-P0128

TM 3-4230-209-20&P

2-96

2-21. SKID BASE SUBASSEMBLY (CONT).

REMARKS

ACTION

LOCATION/lTEM

Skid Base Subassembly/

Replace authorized unserviceable parts.

All components

Skid Base Subassembly/

Clip (1) and screw (2) are required only on Bendix*

Insert clip (1) and fasten with screw (2) to carburetor.

Clip (1)

carburetors.

Screw (2)

Items marked ** should be attached to gasoline

Insert screw (3) through the end of governor control (4) and the bottom

Screw (3)**

engine. Remove and reuse them as they are needed.

hole of the lever on throttle linkage assembly (5). Attach nut (6). Insert

Governor control (4)**

Throttle linkage

carburetor choke stud (7) through the upper hole of throttle linkage

assembly (5)

assembly (5), and attach nut (8). Position throttle linkage assembly (5) in

Nut (6)**

place on top of engine.

Carburetor choke stud (7)**

Nut (8)**

Items marked *** are furnished as parts of throttle

Hexagon head cap

Install hexagon head cap screw (9) through internal tooth lock

linkage assembly (5).

screw (9)***

washer (10), retaining strap (11), throttle linkage assembly (5), and into

Lock washer (10)***

the gasoline engine. Install hexagon head cap screw (9) into gasoline

Retaining strap (11)***

engine three or four turns.

NOTE

Make sure throttle assembly knob on the control panel

assembly is pushed in all the way.

Throttle control cable (12)

Install throttle control cable (12) in throttle adapter (13) and tighten

Throttle adapter (13)

setscrew (14) securely. Tighten hexagon head cap screw (9).

Setscrew (14)***