REASSEMBLY (CONT) - TM-3-4230-209-20-P0095

Pump Unit/Connector Panel

Thread-cutting tapping

Insert thread-cutting tapping screw (10), through flat washer (11), the

screw (10)

hole in the chain (12), and into the panel (13). Tighten. Repeat the opera-

tion for each of the other two chains. Make sure the chain is long enough

Flat washer (11)

Chain (12)

to allow each dust cap (14) to be removed.

Panel (13)

Dust caps (14)

Pump Unit/Fuel Tank and

Sediment Bowl

Fuel tank must be installed in pump unit before the

Fuel tank (15)

Working from the engine end and to the rear

prime tank assembly can be installed.

Fuel tank strap (16)

of the pump unit assembly, position fuel

tank (15) on the frame with the liquid quantity

Gasket (17)

transmitter toward the control panel. Put fuel

tank straps (16), with gasket (17) attached,

over the top of fuel tank (15) and insert the

threaded end through frame holes.

Flat washers (18)

Install four flat washers (18) and four hexagon

Hexagon self-locking

self-locking nuts (19) to the threaded ends of

nuts (19)

the fuel tank straps (16). Tighten four

hexagon self-locking nuts (19).

TM 3-4230-209-20&P

2-63