PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS).

TM 11-6665-230-12

b. Checking Unpacked Equipment.

1. Inspect the equipment for damage incurred during shipment. If the equipment has been

damaged, report the damage on SF 364 (Report of Discrepancy (ROD)).

2. Check the equipment against the packing Iist to see if the shipment is complete. Report all

discrepancies in accordance with the instructions of DA Pam 738-750.

NOTE

If the packing list is missing, then refer to TM 11-6665-230-12-HR.

3. Check to see whether the equipment has been modified. Refer to DA-PAM 310-1 for the cur-

rent MWO information on Radiac Set AN/PDR-27R. If the Radiac Set has been modified, then an MWO

data plate should appear on the case next to the nomenclature plate.

4. To insure that the equipment will be adequately inspected, serviced and operationally

tested before normal everyday use, refer to table 4-1, Service Upon Receipt.

4-3. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS).

a. Use table 4-2 to perform preventive maintenance checks and services to be sure that the Radiac

Set is always ready for use.

b. The Item Number column in table 4-2 should be used when making out DA Form 2404, Equipment

Inspection and Maintenance Work Sheet. The item numbers in the PMCS table go into the TM Number

column on the DA Form 2404.

c. The Procedures column in the table gives instructions to check and have repaired or adjusted as

necessary.

d. If the Radiac Set fails to operate, then follow the maintenance instructions in paragraph 3-2,

Troubleshooting.

NOTE

When performing any PMCS or routine checks, keep in mind the W A R N I N G S

and CAUTIONS shown in this manual.

4-2