SECTION I INTRODUCTION - TM-11-6625-937-40P0003

TM 11-6625-937-40P

SECTION I

INTRODUCTION

Scope

NOTE

This manual lists repair parts and special tools required

Cannibalization or salvage may be

for performance of ID-1189/PR and ID-1189(XE-2)/ PR.

used as a source of supply for any

General

items source coded above except

This Repair Parts and Special Tools List is divided into

those coded XA, XD, and aircraft

the following sections:

support items as restricted by AR

a. Section II. Repair Parts List. A list of repair

70042.

parts authorized for use in the performance of

(2) Maintenance code.

Maintenance

maintenance. The list also includes parts which must be

codes are assigned to indicate the levels of maintenance

removed for replacement of the authorized parts. Parts

authorized to USE and REPAIR support items. The

lists are composed of functional groups in ascending

maintenance codes are entered in the third and fourth

numerical sequence, with the parts in each group listed

positions of the Uniform SMR Code format as follows:

in figure and item number sequence.

(a) The maintenance code entered in

b. Section III.

Special Tools List.

Not

the third position will indicate the lowest maintenance

applicable.

level authorized to remove, replace, and use the support

c. Section IV. National Stock Number and

item. The maintenance code entered in the third position

Part Number Index. A list, in ascending National item

will indicate one of the following levels of maintenance:

identification number (NIIN, last 9 digits) sequence, of all

Code

Application/Explanation

National stock numbers appearing in the listings,

O-Support item is removed, replaced, used at the

followed by a list, in alphameric sequence, of all part

organizational level.

numbers appearing in the listings.

National stock

H-Support item is removed replaced used at the general

number and part numbers are cross-referenced to each

support level.

illustration figure and item number appearance.

(b) The maintenance code entered in

Explanation of Columns

the fourth position indicates whether the item is to be

The following provides an explanation of columns found

repaired and identifies the lowest maintenance level with

in the tabular listings:

the capability to perform complete repair (i.e., all

a. Illustration.

This column is divided as

authorized maintenance functions). This position will

follows:

contain one of the following maintenance codes:

(1) Figure number. Indicates the figure

Code

Application/Explanation

number of the illustration on which the item is shown.

H-The lowest maintenance level capable of complete

(2) Item number. The number used to

repair of the support item is the general support

identify each item called out in the illustration.

level.

b. Source, Maintenance, and Recoverability

Z-Nonreparable. No repair is authorized.

(SMR) Codes.

(3) Recoverability code.

Recoverability

(1) Source code.

Source codes are

codes are assigned to support items to indicate the

assigned to support items to indicate the manner of

disposition action on unserviceable items.

The

acquiring support items for maintenance, repair, or

recoverability code is entered in the fifth position of the

overhaul of end items. Source codes are entered in the

Uniform SMR Code format as follows:

first and second positions of the Uniform SMR Code

Recoverability

format as follows:

codes

Definition

Code

Definition

Z-Nonreparable item. When unserviceable, condemn

PA-Item procured and stocked for anticipated or known

and dispose at the level indicated in position 3.

usage.

H-Reparable item. When uneconomically reparable,

XD-A support item that is not stocked. When required,

condemn and dispose at the general support

item will be procured through normal supply

level.

channels.