APPENDIX B COMPONENTS OF END ITEM LIST

TM 11-6625-937-12

APPENDIX B

COMPONENTS OF END ITEM LIST

Section I. INTRODUCTION

B-1. Scope

This appendix lists integral components of and basic issue items for the ID-1189/PR and the ID-1189(XE-2) PR to help

you inventory items required for safe and efficient operation.

B-2. General

This Components of End Item List is divided into the following sections:

a. Section II. Integral Components of the End Item. These items, when assembled, comprise the ID-1189/PR and

the ID-1189 (XE-2)/PR and must accompany it whenever it is transferred or turned in. The illustrations will help you

identify these items.

b. Section III. Basic Issue Items. These are the minimum essential items required to place the ID-1189/PR and the

ID-1189(XE-2)/PR in operation, to operate it, and to perform emergency repairs. Although shipped separately packed

they must accompany the ID-1189/PR and the ID-1189(XE-2)/PR during operation and whenever it is transferred

between accountable officers. The illustrations will assist you with hard-to-identify items. This manual is your authority

to requisition replacement BII, based on TOE/MTOE authorization of the end item.

B-3. Explanation of Columns

a. Illustration. This column is divided as follows:

(1) Figure number. Indicates the figure number of the illustration on which the item is shown.

(2) Item number. The number used to identify item called out in the illustration.

b. National Stock Number. Indicates the National stock number assigned to the item and which will be used for

requisitioning.

c. Description. Indicates the Federal item name and, if required, a minimum description to identify the item. The part

number indicates the primary number used by the manufacturer, which controls the design and characteristics of the item

by means of its engineering drawings, specifications, standards, and inspection requirements to identify an item or range

of items. Following the part number, the Federal Supply Code for Manufacturers (FSCM) is shown in parentheses.

d. Location. The physical location of each item listed is given in this column. The lists are designed to inventory all

items in one area of the major item before moving on to an adjacent area.

e. Usable on Code. "USABLE ON" codes are included to help you identify which component items are used on the

different models. Identification of the codes used in these lists are:

Code

Used on

ID1189/PR

ID-1189(XE-2/PR

f. Quantity Required (Qty Reqd). This column lists the quantity of each item required for a complete major item.

g. Quantity. This column is left blank for use during an inventory. Under the Rcvd column, list the quantity you

actually receive on your major item. The Date columns are for your use when you inventory the major item.

B-4. Special Information

National stock numbers that are missing from section III have been applied for and will be added to this TM by future

Change/Revision when they are entered in The Army Master Data File (AMDF). Until the NSN's are established and

published, submit exception requisition to: Commander, US Army Communications and Electronics Materiel Readiness

Command, ATTN: DRSEL-MM, Fort Monmouth, NJ 07703 for the part required to support your equipment.

(Next printed page is B-3)

Change 6

B-1