Location of Repair Parts - TM-11-6625-273-20P0004

d. Unit of Measure (U/M). Indicates the standard

Breakdown Test Sets

or basic quantity by which the listed item is used

AN/GSM-6 and AN/GSM-6A.

in performing the actual maintenance function.

1-5. Location of Repair Parts

This measure is expressed by a two-character

a. This manual contains one cross-reference index

alphabetical abbreviation: e.g., ea, in, pr, etc., and is

(sec V) to be used to locate a repair part when either

the basis used to indicate quantities and allowances

the Federal stock number or reference number

in subsequent columns. When the unit of measure

(manufacturer's part number) is known. The first

differs from the unit of issue, the lowest unit of

column in the index is prepared in numerical or al-

issue that will satisfy the required units of measure

phanumeric sequence in ascending order. The refer-

will be requisitioned.

ence numbers ( manufacturer's part numbers) are

e. Quantity Incorporated in Unit. This column

listed immediately following the last listed Federal

indicates the quantity of the item used in the equip-

stock number in the index of Federal stock numbers.

ment.

f. 15-Day organizationtal Maintenance Allowance.

b. When the Federal stock number or reference

(1) The repair parts indicated by an asterisk in

number is known, follow the procedures given in

the allowance column represent those authorized

(1) and (2) below.

for use at the organizational category, and will be

(1) Refer to the index of Federal stock numbers

requisitioned on an "as required" basis, until stock-

(sec V) and locate the Federal stock number or

age is based on demand in accordance with AR 710-2.

reference number. The FSN and reference number

(2) Major Army commanders are authorized to

are cross-referenced to the applicable figure and

approve reduction in the range of support items

item number or reference designation.

authorized for use in units within their commands.

(2) Refer to the repair parts list (sec III) and

Recommendations for increase in range of items

locate the figure number (COl 7a) and item number

authorized for use will be forwarded to Commander,

or reference designation (C Ol 7b) as noted in the

US Army Electronics Command, ATTN: AMSEL-

FSN index.

MA-CRA, Fort Monmouth, N.J., 07703. Any changes

c. When the figure and item number or reference

approved will be reflected in a revision to the RPSTL.

designation are known, scrutinize columns 7a and

(3) Allowance quantities are indicated in the

7b of the repair parts list (sec III) until the item is,

special tools list section for special tools, TMDE,

located.

and other equipment.

d. When the FSN, reference number, figure

g. Illustration. This column is divided as follows

number, item number and reference designation

(1) Figure number. Indicates the figure number

are not known, scrutinize column 3 of the repair

of the illustration on which the item is shown in

parts list (sec III). which is arranged in alphabetical

TM 11-4625-273-12.

order.

(2) Item number. Indicates the item number or

reference designation used to reference the item

in the illustration.

1-6. Abbreviations

1-4. Special Information

Not applicable.

a. Usable on codes are included in column 3. Un-

coded items are applicable to all models. Identifica-

1-7. Reporting of Equipment Publication

tion of the usable on codes used in this publication

Improvements

are--

Code

Used on

The reporting of errors, omissions, and recommends-

AGC

AN/GSM-6

tions for improving this publication by the individual

AGD

AN/GSM-6A

user is encouraged. Reports should be submitted

on DA Form 2028 (Recommended Changes to Pub-

b. The following publication pertains to the equip-

lications) and forwarded direct to Commander, US

ment and its components

TM 11-6625-273-12 Operation and Organizational

Army Electronics Command, ATTN: AMSEL-MA-

Maintenance Insulation

CRA, Fort Monmouth, N.J.. 07703.

(Next printed page is 6.)