CONNECTOR UG-1870A/U REPLACEMENT (CONT) - TM-11-5995-208-24-P-10037

TM 11-5995-208-24&P-1

CONNECTOR UG-1870A/U REPLACEMENT (CONT)

20.

Slide crimp sleeve (4) onto braid.

21.

Place teflon insulator (5) on remaining end of coaxial dielectric.

NOTE

If there is a complete connector assembly already assembled on the opposite end of

cable, a continuity check must be performed to find out whether this end has a male or

female contact. Each coaxial cable must have a male contact at one end and a female

contact at the other end.

Be sure that center contact (6) is butted against teflon Insulator (7), when installing it

on coaxial center conductor.

22.

Install correct center contact (6) onto coaxial center conductor.

23.

Using 60/40 solder, solder center contact (6).

24.

Remove solder flux residue from center contact solder joint.

25.

Repeat steps 18 through 24 on other coaxial line.

3-11