CONNECTOR UG-1870A/U REPLACEMENT (CONT) - TM-11-5995-208-24-P-10034

TM 11-5995-208-24&P-1

CONNECTOR UG-1870A/U REPLACEMENT (CONT)

Be sure to install proper cable grommet (3). There are two variations: one with a round

hole for WD-37A/U cable and one with an oval hole for WD-37/U cable.

12. Install rear backshell (1), cable strain relief (2), cable grommet (3), and front backshell

(4) on cable, and slide back out of the way.

NOTE

Make sure you complete steps 13 through 24 before crimping any of the crimp sleeves. This

will allow you to retrim and regerminate cable, if cable is damaged during any of these

steps.

13. Remove tape from outer braid (5).

3-8